Delta Electronics Ethernet Extension Module DOP Manuel d'utilisateur télécharger pdf (Page 21)

Chapter 3 Before Using eServer

3-8 Revision March, 2014

3.4.2 Synchronize Function

Click Tool > Options to enter eServer Option dialog box. After the box before

“Synchronize Time and Date” is checked, the Synchronize function is enabled and the

users can choose the source of synchronization function shown as the figure below. When

PC is selected, it indicates that the time and date of HMI are both synchronized with the

PC. If a linkage (node) is selected, it indicated that the time and date of HMI and PC are all

synchronized with the selected linkage.

After enable “Synchronize” function, set the timing for synchronizing the time and date.

There are two selections for setting the timing:

one is “Synchronize when starting” and the other is “Synchronize when the following cycle

reaching”. Please refer to the figure below.

If “Synchronize when starting” is selected, the time and date of HMI will be synchronized

when eServer is started. If “Synchronize when the following cycle reaching” is selected and

the cycle time is set to 12 hours, the time and date of HMI will be synchronized once

every 12 hours.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 262 263

Pas de commentaire

Delta Electronics Ethernet Extension Module DOP Manuel d'utilisateur Page 21