Delta Electronics AC Drive VFD-F Series Spécifications télécharger pdf (Page 31)

Chapter 2 Installation and Wiring|VFD-S Series

2-16 Revision August 2008, SE09, SW V2.61

2.4 Wiring

After removing the front cover, check if the power and control terminals are clear of debris. Be sure

to observe the following precautions when wiring.



General Wiring Information

Applicable Codes

All VFD-S series are Underwriters Laboratories, Inc. (UL) and Canadian Underwriters

Laboratories (cUL) listed, and therefore comply with the requirements of the National Electrical

Code (NEC) and the Canadian Electrical Code (CEC).

Installation intended to meet the UL and cUL requirements must follow the instructions provided

in “Wiring Notes” as a minimum standard. Follow all local codes that exceed UL and cUL

requirements. Refer to the technical data label affixed to the AC motor drive and the motor

nameplate for electrical data.

The "Line Fuse Specification" in Appendix B, lists the recommended fuse part number for each

S-Series part number. These fuses (or equivalent) must be used on all installations where

compliance with U.L. standards is a required.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 184 185

Pas de commentaire

Delta Electronics AC Drive VFD-F Series Spécifications Page 31