Delta Electronics TP04 Informations techniques télécharger pdf (Page 51)

Chapter 3 TPEdit Software Operation

3-34

Message Display

Step 1. Choose Object (O

) > Message Show or click the button to get the

following dialog box.

Step 2. HMI will read the PLC corresponding contacts (ON or OFF) or register data

and display the corresponding status on HMI screen. The content of message

could only be text and the text direction of LED message will be scrolls in a

loop as follows: from right to left, from left to right, from top to bottom and from

bottom to top.

Step 3. The max. base state is 255 (Value) or 2 (Bit).

Button

TPEdit provides a series of button for user to use in every kind of occasion. That will

save much time in designing PLC program. Choose Object (O

) > Button or click the

button

to get the following dialog box. The following is the introduction for the

buttons.

ON/OFF button: press this button and HMI will send the contact signal to the PLC

corresponding contact ON or OFF. There are 6 types of ON/OFF

buttons.

ON button: Once you press this button and it will be always ON.

OFF button: Once you press this button and it will be always OFF.

Pulse ON: pressing this contact to send the signal of rising-edge to the PLC

corresponding contact.

$ Pulse OFF: pressing this contact one time to send the signal of falling-edge

to the PLC corresponding contact.

$ Interactive: pressing the contact one time, the contact will be ON and it will

be OFF once you press the contact again.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 77 78

Pas de commentaire

Delta Electronics TP04 Informations techniques Page 51