Delta Electronics TP08 Manuel d'utilisateur télécharger pdf (Page 18)

1 TPEditor Operation

1-16

Figure 1-23

Global Settings

The pull-down options of Global Settings function are described as follows (Figure 1-24):

Figure 1-24

■ System Parameter Setting: After this option is clicked, Parameter Setting tab will appear and allow the

users to enable the function of Page jump automatically/Backlight control, and Read & Write Block Setting.

When

this option is enabled, after the PLC

address, TP address and Length are all set, the system will read the data from the TP register. When

this option is enabled, after the PLC address,

TP address and Length are all set, the system will write the data of the PLC register into the corresponding

TP register. This function is only available for TP05 and TP08 series.

■ System Page Jump Setting: The users can enter page jump conditions in System Page Jump Setting tab.

When the conditions are satisfied, the system will jump to the destination page (screen) and this is called

System Page Jump. It is not necessary to set the conditions for each page. But, once the conditions set in

the page are satisfied, it will jump to the designated page. (If the conditions of System Page Jump conflict

with the conditions of each page, the conditions of each page get high priority.)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 99 100

Pas de commentaire

Delta Electronics TP08 Manuel d'utilisateur Page 18