Delta-electronics Pulse Generator Card PG-03 Manuel d'utilisateur télécharger pdf (Page 3)

PG-03 Terminal Descriptions

Terminals

Terminal Symbols Descriptions

+12V

Power Supply of the Encoder: +12V

Output Voltage: +12V±5% 200mA

0V Common point for the power supply and the signal

Encoder signal input (select the output type of the Encoder from FSW2)

Both single-phase input and two-phase input available

Maximum: 500KP/Sec

A/O, B/O

The Encoder signal output

Maximum: DC24V 50mA

Common point for signal grounding

Wiring Notes

1. Please use a shield cable to prevent interference. Do not run control wire parallel to any high

voltage AC power line (220 V and up).

2. Connect shielded wire to E only.

3. Recommended wire size 0.21 to 0.81mm

(AWG24 to AWG18).

4. Wire length:

The Output Types of the

Encoder

Maximum Wire

Length

Wire Gauge

Output Voltage 50m

Open Collector 50m

Line Driver 300m

Complementary 70m

1.25mm

(AWG16) or above

1 2 3 4

Pas de commentaire

Delta-electronics Pulse Generator Card PG-03 Manuel d'utilisateur Page 3